Candle Care Church Candles Online
Candle Care Church Candles Online
Your source for altar candles, paschal candles, votive candles & religious candles My Account  Cart Contents  Checkout  
  Home » Candle Care   

Advent Candles

Altar & Communion Linens

Altar Candles

Baptism Candles

Candlelight Service

Candlemas Candles

Cemetery Lights

Chace Candles

Christ Candles

Confirmation Candles

Devotional Candles

Electric Candles

Emitte Elite Lights

Emkay Liquid Candles

First Communion Candles

Paschal Candles

Patron Saint Candles

RCIA Candle

Sanctuary Lights

Tea Light Candles

Unclaimed 40% Off

Velas del Sacramento

Votive Candles

Wedding Candles

Newest Products
What's New? more
Plastic Cemetery Candle
Plastic Cemetery Candle
Shipping & Returns
Privacy Notice
Conditions of Use
Contact Us
Beeswax Candles
Candle Care
Unity Candle Ceremony
How to Get Maximum Performance From Your Candles
Many factors can influence the burning performance of a candle. These include not only how the candle is made but how and where it is used.

Things You Should Know About Devotion and Sanctuary Candles

Two types of materials serve as containers for long-burning candles-the open-top plastic container and the "restricted-neck" (often called a bottlelight) glass container.

For the best performance use your Devotion or Sanctuary Lights as follows:

  1. Be sure your lamp fixture is clean and in good condition-and that your candles are the right size for the lamp-and firmly in it.
  2. When lighting the candle, place flame at base of wick. Hold it there for a moment until you see the wax start to melt.
  3. Once a candle is burning AVOID MOVING IT OR EXTINGUISHING IT. Allow the light to burn out completely without interruption to get full rated service. Here's why:
    • If the candle is moved while ignited, liquid wax may drown the wick and extinguish the flame.
    • If the flame is extinguished, and excessive liquid wax solidifies on the wick, the capillary function of the wick is seriously impaired. Thereafter, when the candle is lit again-the flame is seldom clean and smokeless.
How To Get The Most Out of Your Beeswax Altar Candles
  1. Be sure candle and holders are properly matched-so that the candle is firmly supported vertically upright. Tilted candles will drip.
  2. Candle Followers are necessary in controlling the flame and burning rate, and avoiding candle dripping. If the draft is severe and produces too much flickering for the Follower to control-then steps should be taken to divert the flow of air.
  3. Take care in lighting so that only the flame from the candle lighter touches the wick. Never allow any foreign objects, (matches, lighting tapers or sticks) to drop into any candle. This can act as a second wick and will cause an oversized flame, as well as irregular, unsafe burning conditions.
  4. Care in extinguishing is equally important. Hold the snuffer "bell" down over the flame a few moments (long enough to deprive it of oxygen)- but do not jam the snuffer down the wick-or bury it into liquid wax. Either one will make relighting difficult.
  5. If a wick breaks off- trim the head of candle with dull knife blade to expose about _" of fresh wick. Be sure remove any pieces of broken, imbedded wick or char from the candle tip. After trimming, you can relight it as you would a new candle.
  6. Paschal Candle-Ornamentation must be removed before follower reaches ornament. If not removed it will cause candle to burn improperly.
How to Use Candle Followers For Best Results

Observe a few simple precautions, and you will be rewarded with highly satisfactory performance from your Candle Followers. Their operation is based on the law of gravity.

  1. Select a follower of the correct size for the candle diameter. Too large a follower will slide to one side and gradually become unsealed. Too small a follower will bind on the candle and not follow down, as it should.
  2. Followers must be clean to function satisfactorily. Remove all surplus wax from a follower, inside and out, before placing it on a fresh candle.
  3. When positioning a correctly- sized follower on a candle top, give it a quarter twist with slight pressure. This will "seat" the follower so that it will seal properly on the shoulder of the candle.
  4. Once a follower is seated, and especially after the candle has been lighted, do not break the seal. When the seal is disturbed, liquid wax leaks out inside the follower and prevents it from resealing itself. The candle will flood.
  5. To Reseat - First remove surplus wax from follower, and drips from candle. If necessary, trim head of candle to even it up. Then reposition follower on the candles as in No. 3.
Price Range:
01.10 Hour Votive Candles - 288/case
02.5-Day Plastic Light - 24 lights/box - 5 Color Choices
03.3" Paper Drip Protectors- 50 pieces
04.Molded Plastic "Cup" Drip Protectors - 25/box
05.Brass Candle Follower 11/16" to 4"
Show mobile view more

© Copyright 2016 Church Candles Online. All Rights Reserved.

Home   Policies |  Contact |  Beeswax Candles

Powered by OSCommerce